| Specifications | 11-S8E1 hhartenstein |
| Business section |
|
|
|
|
|
||||||||||||||||||||||||||||||||||
|
|
|
|
|
||||||||||||||||||||||||||||||||||
| Specifications | 11-S8E1 hhartenstein |
| Business section |
| Specifications | 11-S8E1 hhartenstein |
| Outline | Front Page Ordering Information Specifications Engineering Data Operation Dimensions Installation Precautions Contacting Omron |
| Suggested Link Details/Purchase | |
| Content | 4Switching Power Supply S8VS Specifications ■Ratings/Characteristics Note:1.Refer to the Engineering Data section on page17 for details.2.If the V.ADJ adjuster is turned, the voltage will increase by more than +15% of the voltage adjustment range (by more than +10% for 240-W models). When adjusting the output voltage, confirm the actual output voltage from the Power Supply and be sure that the load is not damaged. 3.To reset the protection, turn OFF the power supply for three minutes or longer and then turn the power supply back ON.4.Displayed on 7-segment LED. (character height: 8 mm) 5.Resolution of output voltage indication: 0.1 V, Precision of output voltage indication: ±2% (percentage of output voltage value, ±1 digit)6.Resolution of output current indication: 0.1 A; Precision of output current indication: ±5% F.S. ±1 digit max. (specified by rated output voltage)7.Resolution of peak-hold current indication: 0.1 A; Precision of peak-hold current indication: ±5% F.S. ±1 digit max. (specified by rated output voltage); Signal width required for peak-hold current: 20 ms8.A Type and B Type: Sinking, AP Type and P Type: Sourcing9.To ensure the emission rating, a ferrite ring core should be used in all cabling (TDK HF60T, HF70RH or equivalent model). Power ratings60 W90 W Type Item StandardMaintenance forecast monitorTotal run time monitorStandardMaintenance forecast monitorTotal run time monitor Efficiency (typical)78% min.80% min. InputVoltage100 to 240 VAC (85 to 264 VAC) Frequency50/60 Hz (47 to 450 Hz) Current100 V input1.7 A max.2.3 A max. 200 V input1.0 A max.1.4 A max. Power factor- Harmonic current emissionsConforms to EN61000-3-2 Leakage current100 V input0.5 mA max. 200 V input1.0 mA max. Inrush current (See note 1.)100 V input25 A max. (for a cold start at 25°C ) 200 V input50 A max. (for a cold start at 25°C ) OutputVoltage adjustment range (See note 2.)−10% to 15% (with V.ADJ) (guaranteed) Ripple2.0% (p-p) max. (at rated input/output voltage) Input variation influence0.5% max. (at 85 to 264 VAC input, 100% load) Load variation influence (rated input voltage)1.5% max. (with rated input, 0 to 100% load) Temperature variation influence0.05%/°C max. Start up time (See note 1.)1,000 ms max. (at rated input/output voltage) Hold time (See note 1.)20 ms min. (at rated input/output voltage) Additional functionsOverload protection (See note 1.)105% to 160% of rated load current, voltage drop, intermittent, automatic reset Overvoltage protection (See notes 1 and 3.)Yes Output voltage indication (See note 4.)NoYes (selectable) (See note 5.)NoYes (selectable) (See note 5.) Output current indication (See note 4.)NoYes (selectable) (See note 6.)NoYes (selectable) (See note 6.) Peak-hold current indication (See note 4.)NoYes (selectable) (See note 7.)NoYes (selectable) (See note 7.) Maintenance forecast monitor indica-tion (See note 4.)NoYes (selectable)NoNoYes (selectable)No Maintenance forecast monitor output NoYes (open collector output), 30 VDC max., 50 mA max. (See note 8.) No Total run time monitor indication (See note 4.)NoYes (selectable)NoYes (selectable) Total run time monitor outputNoYes (open collector output), 30 VDC max., 50 mA max. (See note 8.) Undervoltage alarm indication (See note 4.)NoYes (selectable)NoYes (selectable) Undervoltage alarm output terminalsNoYes (open collector output) 30VDC max., 50 mA max. (See note 8.) Parallel operationNo Series operationYes for up to 2 Power Supplies (with external diode) OtherOperating ambient temperatureRefer to the derating curve in Engineering Data. (with no icing or condensation) Storage temperature−25 to 65°C Operating ambient humidity25% to 85% (Storage humidity: 25% to 90%) Dielectric strength3.0 kVAC for 1 min. (between all inputs and outputs/ alarm outputs; detection current: 20 mA) 2.0 kVAC for 1 min. (between all inputs and PE terminals; detection current: 20 mA)1.0 kVAC for 1 min. (between all outputs/ alarm outputs and PE terminals; detection current: 20 mA)500 VAC for 1 min. (between all outputs and alarm outputs; detection current: 20 mA) Insulation resistance100 MΩ min. (between all outputs/ alarm outputs and all inputs/ PE terminals) at 500 VDC Vibration resistance10 to 55 Hz, 0.375-mm single amplitude for 2 h each in X, Y, and Z directions Shock resistance150 m/s2, 3 times each in ±X, ±Y, and ±Z directions Output indicatorYes (color: green) EMIConducted EmissionsConforms to EN61204-3 EN55011 Class A and based on FCC Class AConforms to EN61204-3 EN55011 Class B (See note 9.) Radiated EmissionsConforms to EN61204-3 EN55011 Class AConforms to EN61204-3 EN55011 Class B (See note 9.) EMSConforms to EN61204-3 Class B Approved standardsUL: UL508 (Listing; Class 2: Per UL1310), UL60950cUL: CSA C22.2 No.14 (Class 2), No.60950 EN/VDE: EN50178 (=VDE0160), EN60950 (=VDE0805)SELV (EN60950/EN50178/UL60950-1)According to VDE0106/P100, IP20 UL: UL508 (Listing), UL60950cUL: CSA C22.2 No.14, No.60950EN/VDE: EN50178 (=VDE0160), EN60950 (=VDE0805)SELV (EN60950/EN50178/UL60950-1)According to VDE0106/P100, IP20 Weight330 g max.490 g max. |
| Navigation | Previous Page / Next Page |
| Suggested Link Details/Purchase | |
| Following Datasheets | power_supply_brochure (2 pages) pps_datasheet-1 (13 pages) pp_series (2 pages) PR05-PCB_Brochure_5-20-11 (1 pages) pr36mf1_e (15 pages) pr36mf2_e (15 pages) PRAndersonPower-2 (2 pages) PRArcticSilicon (2 pages) PRCreeXlampXPG (2 pages) precidipcustomdesign (9 pages) |
Check in e-portals |
World-H-News Products Extensions Partners Automation Jet Parts |
| Sitemap Folder | group1 group2 group3 group4 group5 group6 group7 group8 group9 group10 group11 group12 group13 group14 group15 group16 group17 group18 group19 group20 group21 group22 group23 group24 group25 group26 group27 group28 group29 group30 group31 group32 group33 group34 group35 group36 group37 group38 group39 group40 group41 group42 group43 group44 group45 group46 group47 group48 group49 group50 group51 group52 group53 group54 group55 group56 group57 group58 group59 group60 group61 group62 group63 group64 group65 group66 group67 group68 group69 group70 group71 group72 group73 group74 group75 group76 group77 group78 group79 group80 group81 group82 group83 group84 group85 group86 group87 group88 group89 group90 group91 group92 group93 group94 group95 group96 group97 group98 group99 group100 Prewious Folder Next Folder |
