LOGO eng AK4018

We use cookies to personalise content and ads, to provide social media features and to analyse traffic. We share info about use of our site with social media, ads and analytics partners. By continuing to browse you are agreeing to use of cookies. See details or close this message.

Page

/235

100%

Specifications	LOGO eng AK4018
Business section

Specifications	LOGO eng AK4018
Suggested Link Details/Purchase
Content	LOGO! ManualA5E00067781 018 2Installing and Wiring LOGO! General guidelines You should keep to the following guidelines when you install and wire your LOGO!: Ensure that you comply with all the valid and mandatory standards when wiring your LOGO! device. You should also heed any national and regional regulations when installing and operating the devices. Contact the rele- vant authorities to find out the standards and regula- tions that apply in your specific case. Use wires with the appropriate cross-section for the amount of current involved. You can wire LOGO! using wires with a cross-section of between 1.5mm2 and 2.5mm2 (see Section 2.2). Don’t screw the connectors too tightly. The maximum torque is 0.5Nm (see Section 2.2). Keep wiring distances as short as possible. If longer wires are necessary, a shielded cable should be used. You should lay wires in pairs: a neutral conductor to- gether with a phase conductor or signal conductor. Isolate AC wiring and high-voltage DC wiring with rapid operating sequences from low-voltage signal wiring. Ensure that the wires have the required strain relief. Provide suitable overvoltage protection for wires that could be vulnerable to lightning. Do not connect an external power supply to an output load parallel to a DC output. This can result in reverse current at the output unless you have a diode or a simi- lar block in your configuration.
Navigation	Previous Page / Next Page
Following Datasheets	6_cz (117 pages) 6_en (256 pages) APB_EIB_en (8 pages) appex_micro_10a_v1_0_en (89 pages) appex_micro_10_v1_0_en (81 pages) appex_micro_1_v1_0_en (91 pages) appex_micro_5_v1_0_en (79 pages) BA_BEDIENGERAET_XP170X_en (252 pages) bop_aop_single_drive_mount_kit_en (2 pages) brochure_micro_10_2005_cz (24 pages)
Check in e-portals	World-H-News Products Extensions Partners Automation Jet Parts
Sitemap Folder	group1 group2 group3 group4 group5 group6 group7 group8 group9 group10 group11 group12 group13 group14 group15 group16 group17 group18 group19 group20 group21 group22 group23 group24 group25 group26 group27 group28 group29 group30 group31 group32 group33 group34 group35 group36 group37 group38 group39 group40 group41 group42 group43 group44 group45 group46 group47 group48 group49 group50 group51 group52 group53 group54 group55 group56 group57 group58 group59 group60 group61 group62 group63 group64 group65 group66 group67 group68 group69 group70 group71 group72 group73 group74 group75 group76 group77 group78 group79 group80 group81 group82 group83 group84 group85 group86 group87 group88 group89 group90 group91 group92 group93 group94 group95 group96 group97 group98 group99 group100 Prewious Folder Next Folder